Kenmore 911.40465 Owner's Manual page 19

CARE ANDCLEANING
RemovableParts
Broil Stop Position
CLEANING MATERIALS
• Dishwashing detergent
° Warm water
° Scouring pad or soap-filled steel wool
pad
Raised Back
of The Rack
Hinge
TO REMOVE
1. Open the door to the broil stop
position.
2, Grasp the door at each side and lift
up and off the hinges DO NOT
LIFT DOOR BY THE HANDLE.
TO REMOVE
1, Pull the racks out to the stop lock
position.
2. Pull up the front of the rack and
slide under the bump off the rack
guide.
TO CLEAN
Clean with warm water and detergent.
For hard to remove stains, gently scrub
with a scouring pad or a soap-filled
steel wool pad. Rinse well.
TO REPLACE
1. Place the raised back of the rack
onto the rack guides
2 Lift the front of the rack until the
raised back slides under the bump
of the rack guides
8, Slide the rack all the way back.
TO REPLACE
1, Make Sure the hinge arms are in the
broil stop position.
2, Lift the door by the sides.
3, Line up the slots at the bottom edge
of the door with the hinge arms
4, Slide the door down onto the hinge
arms as far as it will go.
5. Ctose the door.
19