Kenmore 116.33920 Owner's Manual page 18

Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the cleaner
without the primary or exhaust filters.
Be sure the filters are properly
installed to prevent motor failure
and/or electrical shock.
PRIMARY FILTER
Check primary filter frequently and clean
when dirty.
TO REMOVE PRIMARY FILTER
Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN
CLEANING section.
While holding
primary filter
over a trash con-
tainer grasp fil-
ter, rotate and lift
off.
Cleaning Cam
Slot
Filter
\ , Locking Tab
Filter Cover
Clean primary filter by gently tapping over a
trash container. Tap on several sides to
ensure best cleaning, Rinse with water
only as needed, do net use any detergent
or soap. Allow the filter to dry for 24 hours
before putting it back into the vacuum.
When cleaning the filter no longer restores
vacuum suction to full power you need to
replace the filter.
TO REPLACE PRIMARY FILTER
With slot side
on filter towards
the filter cover,
slide cleaning
cam inside
opening, rotate
filter clockwise
until slots lock
onto tabs in
cover.
Cleaning Cam
_=_1 Slot
_,,- I Filter
Niter Cover
Note: Under normal use and care, your fil-
ter can be expected to last up to 5 years.
Re-assemble dust bin lid to dust bin. Insert
into cleaner and secure with dust bin latch.
EXHAUST FILTER
HEPA
The exhaust filter must be replaced when
dirty, it should be replaced regularly
depending on use conditions.
The filter CANNOT be washed as it will
lose its dust trapping ability.
Note: See PARTS AND FEATURES
for the exhaust filter number.
Remove filter cover by pulling out at the top
of the
Exhaust
I_, _) \ exhaust ill-
Filter t\;q_L"'_ I _ ter cover.
Exhaust _
_ Remove _
FilterCover _"_=_\\_ \ YI
u/_!_ __filter car _the exhaust
_ tridge.
Her
_Bottom "_
Tabs
Push only on filter cartridge frame, not on
Exhaust
Filter Seal
filter material itself.
The seal of the filter should be placed
against the vacuum cleaner body
Replace the exhaust filter cover by placing
bottom tabs in slots and pushing in until
cover snaps into place.
18