Kenmore 580.72066 Owner's Manual page 7

_lput the Support Bracket against the outside
wall and tighten the Bolts on top of the Bracket.
Adjust the Leveling Bolt so thai the air conditioner
will be installed with a very slight tilt (about 1/4")
downward toward the outside for proper drainage.
Tighten the nut. (Fig. 3)
NOTE: DO NOT drill a hole in the bottom of the
base pan. The air conditioner is designed to
operate with the bottom of the base pan
approximately half-fuU of water.
About I/4"-_
_Ii FIG. 3
_-"_ Fasten Side Guides to the sides of the Air
Conditioner using 3 Type A screws per Guide.
Start with first screw at middle of Guide. (Fig. 4)
r_ Fasten upper Guide on the top of the Air
Conditioner using 3 Type A screws. (Fig. 4)
Fastening Side Guides
Upper Guide
Side Guide
FIG. 4
i_ Measure height of window opening from top of
Bracket assembly as shown Fig. 5. Subtract 20-3/4
inches. Mark this measurement on Curtain and cut
the Curtain. (Fig. 5)
_r_ Slide Curtain into Curtain Frame. Slide Curtain
Frame assembly into side Guides of the Air
Conditioner cabinet, Make sure Curtain is firmly
enclosed on all sides by the Frame. (Fig. 6)
in Frame
Cudain_
FIG. 6
_Cut side Guide seal into 2 equal lengths.
Remove protective backing and apply it to the rear
side of cabinet Side Guides, starting just below
Curtain Frame assembly, Pinch off excess length so
seal is even with the bottom of side Guide. (Fig. 7)
Apply weather seal
to side guides
just below edge of
Curtain Frame.
FIG. 7
-7-