Kenmore 1218 Instructions Manual page 30

WHAT TO DO
I III I IIHIII IIH IIII I II IIIIIIIIIIIIIIIIII I m II III II / IIIIIIIIIIIIII I! I, ,ll,,,,,,,,, . i
PROBLEM PROBABLE CAUSE CORRECTION
Irregular
Stitches
Breaking
Needle
Bunching of
Thread
Puckering
Incorrect size needle,
Improper threading.
Loose upper thread tension.
Pulling fabric,
Light pressure on presser foot,
Loose presser foot,
Unevenly wound bobbin.
Nicks or burrs on shuttle,
Nicks or burrs at hole of needle
plate,
Choose correct size needle for thread and fabric.
Rethread machine.
Tighten upper thread tension,
Do not pull fabric; guide it gently.
Increase pressure on presser foot.
Reset presser foot.
Rewind bobbin.
Replace shuttle, or polish off burrs completely.
Replace needle plate, or polish off burrs completely,
Pulling fabric,
Incorrect size needle,
Incorrect setting of needle,
Loose presser foot,
Do not pull fabric; guide it gently.
Choose correct size needle for thread and fabric,
Reset needle.
Reset presser foot.
Upper and lower threads not drawn
back under presser foot before
starting seam,
When starting a seam be sure to draw both threads under and
back of presser foot about 4"" and hold until a few stitches
are formed,
Incorrect thread tension(s).
Light pressure on presser foot.
Using two different sizes or kinds
of thread,
Bent or blunt needle.
Loose presser foot.
Fabric too sheer or too soft.
Reset thread tension(s).
Increase pressure on presser foot,
Upper thread and bobbin thread should be same size and kind,,
insert new needle,
Reset presser foot,
Use undeday of tissue paper.
3O