Kenmore 1218 Instructions Manual page 28

i_er
lever
Shutt_
hook
Shuffle Race Cover Shuttle
shuttle driver
It may be necessary to clean the shuttle area occasionally.
1. Raise the needle bar to its highest position and remove bobbin case.
2. Push levers sideways of the shuttle assembly and lift shuttle and shuttle race cover.out by the center pin.
3. Clean the shuttle race of any lint or small particles of thread with a small brush.
4. Put a drop of oit on the center pin of the shuttle and on shuttle race (see arrows).
To reassemble, hold shuttle by center pin and fit carefully into assembly opposite the shuttle driver.
Slip shuttle race cover into place. Snap the levers into position.
Occasionally, remove the needle plate and clean feed dog with a soft brush.
28