Cooking Utensils; Radiant Coils; Control Settings; Dual Cooking Zone - Kenmore 911.95579 Owner's Manual

OPERATION
Radiant CooktopCooking
When the knobs are turned on, coils
beneath the glass radiate heat
through the glass to the cooking
utensil, it will take a few minutes for
the coils to heat; as they do, a red
glow can be seen on the surface of
the cooktop.
1. Push down to turn
the knob,
u
Set on or between o
numbers for .__'_o/_
desired heat.
/___
The surface udit indicator light will
glow when any cooking zone is
activated.
It is normal to see the elements glow
red and then dark while cooking at
settings below high. This cycling on
and off is used to maintain your
selected control setting, Cycling when
the selector is set on Hi is due to poor
transfer of heat to cookware that is not
flat. The Temperature Limiters of the
cooking zones provide a protection
for your new cooktop. The Limiters will
turn the radiant coils on and off while
cooking or canning. This procedure
helps maintain an even cooking
temperature without allowing the
cooking zones to overheat.
Hg
MED
LO
Used for quick starts, such as
bringing water to a boil.
Used for slow boil and
sauteing,
Used for steaming foods or
keeping cooked foods at
serving temperature.
The left front element has two cooking
zones:
Dual Cooking Zones
(Left Front Element Only)
9" Zone For Large Utensils
6" Zone For Small Utensils
To use the large 9" 9" Zone
cooking area, push in the Q
top portion of the rocker
switch next to the control
knob and push to turn
the control knob to
desired setting, o
6" Zone
To use the small 6" cooking area,
push in the bottom portion of the
rocker switch and push to turn the
control knob to desired setting,
10