Operation; "Dry" Vacuuming - Kenmore 175.8579280 Owner's Manual

OPERATION
TO, EMPTY THE SOLUTION TANK
See Figure 11
When cleaning is completed, both the Recovery Tank and the
Solution Tank should be emptied prior to storage. Empty the
Recovery Tank as described earlier. There are three methods
of emptying the Solution Tank.
Method 1 :
1. Disconnect Pump Cord from Recovery Tank.
2. Remove Recovery Tank from Solution Tank and pour
solution out of the Filler Opening.
Method 2"
1. Place Floor Nozzle in bath tub or container.
2. Depress Solution Release Trigger and spray until empty.
Method 3:
1. Remove Floor Nozzle and insert Wand into Solution Tank
through the Filler Opening.
2. Vacuum solution out.
3. All solution is now in Recovery Tank. Empty Recovery
Tank as described earlier.
METHOD 1
METHOD 2
Fig. 11
METHOD 3
ADDITIONAL U
"DRY" VACUUMING
See Figure 12
KEY PART NO. DESCRIPTION
1 643076-008 Floor/Rug Nozzle
2 642458-004 10" Squeegee
3 660408-001 Cloth Filter Assembly
Included with your cleaner are accessories to convert your
cleaner to perform dry vacuum cleaning.
1. Insert the Cloth Filter into the Recovery Tank.
2. Use the Floor/Rug Nozzle or the Squeegee Nozzle as
desired.
NOTE: You MUST use the Cloth Filter when "dry" cleaning.
NOTE: Squeegee Nozzle is also useful in "pick up" operation
of "wet" cleaning.
USE AS A BLOWER
See Figure 13
1. Insert Hose into the Exhaust Port of the Power Head.
2. Turn Power Switch "ON" and direct hose to area to be
blown.
Fi#. 12
EXHAUST
PORT
Fig. 13
Page 8