Pump Switch - Kenmore 175.8579280 Owner's Manual

P O
CARPET PREPARATION
For best results prepare carpet for cleaning as follows:
1. Vacuum carpet to remove loose dirt before using Cleaner.
2. To remove stains and ground in dirt present in heavy traffic
areas of the carpet, spray or rub Sears Heavy Traffic Pre-
Treatment (82833) into carpet before using Cleaner. Follow
directions on the bottle.
FILLING CLEANER WITH WATER AND
CLEANING SOLUTION
See Figure 4
1. Open lid of the Filler Opening.
2. Add Sears All In One Carpet Cleaner (82813) solution or
Sears Upholstery Cleaner (82843) solution to Solution Tank
(depending on type of cleaning to be performed). Follow di-
rections on label of bottle.
3. Pour clean, hot water (from tap) into Filler Opening in the
Solution Tank -- use two (2) gallons of water.
4. Close Filler Opening.
NOTE: This unit may become damaged if boiling water is used.
FILLER
OPENING
Fig. 4
JTION
TANK
POWER CORD AND SWITCH
See Figure 5
1. Unwrap Power Cord from around Power Head and plug into
electrical outlet.
2. Turn Power Switch to "ON" position.
PUMP SWITCH
See Figure 5
1. Place Pump Switch from "OFF" position to either "HI" or "LO"
position.
NOTE: "HI" pump speed is used for normal cleaning. "LO" pump
speed is used for delicate upholstery or light cleaning.
POWER CORD
PUMP
SWI
Fig. 5
POWER
SWITCH
--Continued--
Page 5