Removing And Replacing The Lift=Off Oven Door; Special Door Care Instructions - Frigidaire FGGS3065KFC Use & Care Manual

Built-in range
Hide thumbs Also See for FGGS3065KFC:
Table of Contents

Advertisement

Removing and replacing the lift=off oven
door
The door is heaw. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor -
See Figure 1).
2.
Pull the door hinge locks on both left and right
door hinges down from the oven frame completely
towards the oven door (See Figure 2). A tool such as
a small fiat-blade screwdriver may be required.
3.
Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
4.
Close the door to the broil stop position (the oven
door will stop into this position just before fully
closing).
5,
With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 4).
To Replace Oven Door:
1.
Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
2.
Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm over
the roller pins located on each side of the oven door
frame (See Figure 4). The hook of the hinge arms
must be fully seated onto the roller pins.
3.
Fully open the oven door (horizontal with floor - See
Figure 1).
4.
Push the door hinge locks up towards and into the
oven frame on both left and right oven door hinges
(See Figure 2) to the locked position.
5.
Close the oven door.
Oven door =
J
Figure 4
Hinge
.....
Figure 3
Special door care instructions
- Most
oven
doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are
fully in place.
2. Do not hit the glass with pots, pans, or any other ob-
ject.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
Changing
oven light
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the
oven light on during a self-cleaning cycle, High
temperature will reduce lamp life.
On some models an interior oven light will turn on
automatically
when the oven is opened. The oven light
may be turned on when the door is closed by using the
oven light switch located on the Electronic Oven control.
The oven light bulb is covered with a glass shield held
in place by a wire holder. THIS GLASS SHIELD MUST
ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
Door Hinge locations
with oven door fully open
Figure 1
Figure 2
BE SURE OVE" I SCOOL ...........................................
To
1.
2.
3,
4,
Replace the Light Bulb:
Turn the power off at the main source.
Wear a leather-faced glove for protection against
possible broken glass.
Replace bulb with a 40
Watt appliance bulb only.
For selFcleaning oven,
press wire holder to one
side to release glass
shield, change bulb and
be sure to replace glass
shield.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents