Removing & Replacing The Lift-Off Oven Door - Frigidaire GLEF389HBB Use & Care Manual

Es530 control, self-cleaning oven with ceramic cooktop
Table of Contents

Advertisement

Door
Hinge
locations
with
oven
door
fully
open
Fig. 1
Fig. 2
Oven
Door.
Fig. 3
Hook
Fig. 4
Do not use the following
on the ceramic
glass cooktop:
, Do not use abrasive cleaners and scouring pads, such as metal and some nylon
pads. They may scratch the cooktop, making it more difficult to clean.
, Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as
they may etch or discolor the cooktop.
, Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on
the cooktop which can burn and cause discoloration.
Special Caution for Aluminum
Use on the Ceramic Cooktop:
Aluminum
Foil =Use of aluminum foil on a hot cooktop will damage the ceramic
cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to
touch the ceramic cooktop under ANY circumstances.
Aluminum
utensils
- The melting point of aluminum is much lower than that of
other metals. Care must be taken when aluminum pots or pans are used on the
cooktop. If allowed to boil dry, not only will the utensil be destroyed, but it may
fuse to, break or mark the ceramic glass surface, permanently damaging the
cooktop surface.
Removing
& Replacing
the Lift-Off Oven Door
The door is heavy. For safe, temporary storage, lay the door flat
with the inside of the door facing down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor - See Fig. 1).
2.
Pull the door hinge locks on both left and right door hinges down from the
oven frame completely towards the oven door (See Fig. 2). A tool such as a
small fiat-blade screwdriver may be required.
3.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
4.
Close the door to the broil stop position (the oven door will stop into this
position just before fully closing).
5.
With the oven door in the broil stop position, lift the oven door hinge arms over
the roller pins located on each side of the oven frame (See Fig. 4).
To Replace Oven Door:
1.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
2.
Holding the oven door at the same angle as the removal position, seat the
hook of the hinge arm over the roller pins located on each side of the oven
door frame (See Fig. 4). The hook of the hinge arms must be fully seated
onto the roller pins.
3.
Fully open the oven door (horizontal with fioor - See Fig. 1).
4.
Push the door hinge locks up towards and into the oven frame on both left
and right oven door hinges (See Fig. 2) to the locked position.
5.
Closetheoven
door.
Door Care Instructions
- Most oven doors contain glass that can break.
Read the following
recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching, hitting, jarring or stressing the glass may weaken its structure
causing an increased risk of breakage at a later time.
32

Advertisement

Table of Contents
loading

Table of Contents