Frigidaire FGGS3065PF Installation Instructions Manual
Frigidaire FGGS3065PF Installation Instructions Manual

Frigidaire FGGS3065PF Installation Instructions Manual

30" gas slide-in range
Hide thumbs Also See for FGGS3065PF:

Advertisement

INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
United States
Canada
Refer to your serial
plate for applicable
agency certification.

Table of Contents

Important Safety Instructions .......................................... 2
Product & Cabinet Dimensions.................................... 3-4
To Avoid Breakage .......................................................... 5
Before Starting................................................................ 6
Cabinet Construction ................................................... 6-7
Provide an Adequate Gas Supply................................... 7
Seal the Openings .......................................................... 7
Connect the Range to the Gas Supply ........................ 7-8
LP/Propane Gas Conversion .......................................... 8
Electrical Requirements.................................................. 8
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing range.
2. Remove all packing material from the oven and the
drawer compartments before connecting the gas and
electrical supply to the range.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
5. Note: For operation at 2000 ft. elevations above see
level, appliance rating shall be reduced by 4 percent for
each additional 1000 ft.
Important Note to the Consumer
Keep these instructions with your owner's guide for the
local electrical inspector's use and future reference.
P/N 318201697 (1507) Rev. B
English - pages 1-14; Spanish - pages 15-28; French - pages 29-44
30" GAS SLIDE-IN RANGE
If the information in this manual is not followed exactly, a fire
or explosion may result causing property damage, personal injury or death.
FOR YOUR SAFETY:
- Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in your
building.
Immediately call your gas supplier from a neighbor's phone. Follow the
gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
- Installation and service must be performed by a qualified installer,
service agency or the gas supplier.
Anti-Tip Brackets Installation ..................................... 9-10
Range Installation ..........................................................11
Leveling the Range....................................................... 12
Decorative Rear Trim Installation ................................. 12
Check Operation...................................................... 13-14
When All Hookups are Complete.................................. 14
Model and Serial Number Location .............................. 14
Before You Call for Service........................................... 14
Appliances Installed in the state of
Massachusetts:
This Appliance can only be installed in the state of
Massachusetts by a Massachusetts licensed plumber or
gasfitter.
This appliance must be installed with a three (3) foot / 36
in. long flexible gas connector.
A"T" handle type manual gas valve must be installed in
the gas supply line to this appliance.
Cold temperature can damage the
electronic control. When using the appliance for the
first time, or when the appliance has not been used
for an extended period, be certain the unit has been
in temperatures above 32°F (0°C) for at least 3 hours
before turning on the power to the appliance.
Printed in United States

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FGGS3065PF and is the answer not in the manual?

Questions and answers

Summary of Contents for Frigidaire FGGS3065PF

  • Page 1: Table Of Contents

    INSTALLATION INSTRUCTIONS 30" GAS SLIDE-IN RANGE INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. United States If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
  • Page 2: Important Safety Instructions

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) IMPORTANT SAFETY INSTRUCTIONS This manual contains important safety symbols and instructions. Please pay attention to these symbols and follow all instructions given. This symbol will help alert you to situations that may cause serious bodily harm, death or property damage.
  • Page 3: Product & Cabinet Dimensions

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Product Dimensions 21¾” (55.25 cm) Do not install the unit in the cabinet before reading next two pages. Door Open (see note 5) Side Panel A. HEIGHT D. TOTAL DEPTH E.
  • Page 4 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Cabinet Dimensions 1 ½" Max. Shave (3,8 cm Max.) Raised Edge to Clear Space for a " min (80 These surfaces should be flat & leveled cm) Wide Cooktop. (hatched area).
  • Page 5: To Avoid Breakage

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) To avoid breakage: Do NOT handle or manipulate the unit by the cooktop. The counter-top around the cut-out should be flat and leveled (see hatched area on illustration 1). Before installing the unit, measure the heights of the two (2) cabinet sides (H1-4), front and back (see illustration 1) from the floor to the top of the counter.
  • Page 6: Before Starting

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Before Starting Tools you will need For leveling legs and anti-tip brackets: Min. ● Adjustable wrench or channel lock pliers Cutout Width ● 1/4" (7mm) Nutdriver ● 3/8" (10mm) Nutdriver Formed or tile ●...
  • Page 7: Provide An Adequate Gas Supply

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) • If you are using a through the floor gas entry, remove Connect the range to the gas the line protector shield from the bottom of the unit to supply allow access for the pipe line (figure 3).
  • Page 8: Lp/Propane Gas Conversion

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Once regulator is in place, open the shutoff valve in the Do not use an extension cord with this range. gas supply line. Wait a few minutes for gas to move Grounding Instructions through the gas line.
  • Page 9: Anti-Tip Brackets Installation

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) 1. Draw a center line (CL) on the floor where the range Anti-Tip Brackets Installation should be installed. Also draw a line on the floor at Instructions the range back position if there is no wall. Models Equipped with Leveling Device 2.
  • Page 10 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) C. Level and position the range - Slide range to its Models Equipped with Leveling Legs final position. Insert the range leveling leg in the anti-tip bracket. Visually verify if the anti-tip bracket is engaged. To reduce the risk of tipping of the range, the range must be secured to the floor by the Lower the range by adjusting the 4 leveling legs...
  • Page 11: Range Installation

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Range Installation Adjust leveling legs so that the underside of the 9.13 cooktop is sitting on the countertop. Carefully Important Note: Door removal is not a requirement for screw in (refer to Leveling the range: Models installation of the range, but is an added convenience.
  • Page 12: Leveling The Range

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Leveling the Range Models Equipped with Leveling Device 10.1 Level the range after installation in the cutout opening. 1. Open the range drawer. The leveling screws control the height of the rear leg. 2.
  • Page 13 30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Check the Igniters To prevent flare-ups and avoid 12.3 Operation of electric igniters should be checked after creation of harmful by-products, do not use the cooktop range and supply line connectors have been carefully without all burner caps properly installed to insure proper ignition and gas flame size.
  • Page 14: When All Hookups Are Complete

    30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS (Models with Sealed Top Burners) Operation of Oven Burners and Oven oven bottom out of the oven. Remove burner baffle so 12.5 that burner flame can be observed. Adjustments If the flame is yellow, increase air shutter opening size 12.5.1 Electric Ignition Burners (see "2"...

Table of Contents