Table of Contents
Advertisement
Note:
Prior
to assembly
remove
protective
film from
stainless
steel parts
Fig. 1
Wheel
Channel
Cart Assemblw
Door Stops & Door Pivot Bolts
1.
Attach the two L-shaped sides to the back portion
of the cart, making sure the two holes face up &
the key holes are on the top, using the (4) self
tapping hex head screws. (See Fig. 1)
Note:
A power
screwdriver
is required
to install the
screws-be
cautious
not to over-tighten
and strip
the screws.
.
Set the base on the top of the cart assembly,
with
large opening closer to back portion of cart, and
align the eight mounting
holes. Then set the 2
wheel channels
on the base and attach them using
the (8) bolts provided,
from inside the cart
upwards
through wheel
channels.
(See Fig. 2)
Note:
Tighten
the bolts securely
3.
Door Stop: Insert Door Stop Bolt downward
from bottom
side of Cart Base through the hole
found in the right/front
of the base.
(See Fig 3)
.
Screw Rubber Cap onto Bolt from the topside of
Cart Base and tighten securely. (See Fig 4)
.
Door Pivot Bolt: Insert Bolt downward
from
bottom side of Cart Base through the hole %und
in the left/front
of the base and secure with
bolt.
(See Fig. 2)
Fig. 4
Fig. 2
Fig. 3
Advertisement
Table of Contents
