Table of Contents
Advertisement
| BasicRecording
NOTE:
Before continuing,
perform the procedures
listed
below:
• Power (
pg. 13)
• Loading A Cassette
(:
pg. 18)
VIDEO/MEMORY
--
Zoom Lever
- POWER/CHARGE
Lamp
- Lock Button
Recording
Start]Stop
Button
1 Remove
the lens cap.(-pg•12)
2
Open the LCD monitor fully.
3
Set the VIDEO/MEMORY
Switch
to "VIDEO".
4
Set the Power Switch
to "REC" while pressing
down the Lock Button
located
on the switch,
• The POWER/CHARGE
lamp lights and the
camcorder
enters the Record-Standby
mode.
"_
PAUSE" is displayed.
oTo record in LP (Long Play) mode, •
pg. 32.
5 To start
recording,
press the Recording
Start/
Stop Button. "_
REC" appears
on the display
while
recording
is in progress•
6
To stop recording,
press the Recording
Start/
Stop Button
again. The camcorder
re-enters
the
Record-Standby
mode.
Approximate
recording
time
Recording ='node
Tape
SP
LP
30 min.
30 min.
45 rnin.
60 min.
60 min.
90 rnin.
80 min.
80 min.
120 min.
NOTES:
• If the Record-Standby
mode continues
for
5 minutes and no operation is performed
("_
PAUSE" indicator
may not appear), the
camcorder's
power shuts off automatically.
To turn
the carncorder
on again, push back and pull out
the viewfinder again or close and re-open the LCD
monitor.
VIDEO RECORDING EN
19
• When a blank portion is left between
recorded
scenes on the tape. the time code is interrupted
and errors may occur when editing the tape. To
avoid this, refer to 'Recording
From The Middle Of
A Tape" (
- pg. 21 ).
• To turn the melody sounds off,
pg. 33.
Tape Remaining Time
Approximate
tape remaining
time appears
on the display•
- - - min" means the
camcorder
is calculating
the
remaining
time. When
the
remaining
time reaches
2 minutes,
the indication
starts
blinking.
• The time required to calculate
and display the
remaining tape length, and the accuracy of the
calculation,
may vary according to the type of tape
used.
LCD Monitor AndViewfinder
>-
While
using
the LCD monitor:
e-
Make sure the viewfinder
is pushed
back in, Pull
'_
on the end @ of the LCD monitor
and open the
LCD monitor fully• It can rotate 270 ° (90 °
m
downward,
180 ° upward)•
o
180°
90°
While
using
the viewfinder:
Make sure the LCD monitor
is closed
and
locked. Pull out the viewfinder
fully.
NOTES:
• The image will not appear simultaneously
on the
LCD monitor and the viewfinder.
When the
viewfinder is pulled out while the LCD monitor is
opened, you can select which one to use. Set
"PRIORITY"
to the desired mode in SYSTEM
Menu. (: • pg. 33)
• Colored bright spots may appear all over the LCD
monitor or the viewfinder.
However, this is not a
malfunction.
(:-
pg. 47)
Advertisement
Table of Contents
