Advertisement
e!eeau!;10n
Installation
• Install in a place which is level, dry amt neither too hot nor
toocokl
between
5 C and 3_ C.
• Install the System
in a location
with adequate
ventilation
to
prevent internal
heat buildup
in the System.
DONOT
install the System
in a location
near heat
or in a place subject to
sources,
direct sunlight,
excessive
(lust or vibration.
• Leave sufficient
distance
between
the System
and the TV.
• Keep the speakers
away fi'om the TV to avoid interference
with TV.
Power sources
• When unplugging
tile System
fi'om tile wall outlet, always
pull on the plug, not the AC power
cord.
{
...........................................................................................................................................................
{
A
DO NOT handle
the AC power cord with
wethands,
Moisturecondensation
Moisture
may condense
on tile lenses inside the System
in
the lbllowing
cases:
• After starting
to heat the room
• I11a damp
1"00111
• If the System
is brought
directly from a cold to a v,_arm
place.
Should this occur, the System
may malflmction.
In this case,
leave the System
turned on for a few' hours until the moisture
evaporates,
unplug
the AC power
cord, then plug it in again.
Internal heat
• A cooling
fan is mounted
on tile rear panel to prevent
heat
buildup
inside tile unit.
.....
<
For safety, observe the foUowingcarefully:
• Make sure there is __ood ventilation
around
the unit. Poor ventilation
could overheat
A
and damage
the unit.
.Do N OT block
the c ool,ng
fan a nd the
Others
• Should any metallic
object or liquid fall into tile System,
anplug the AC power cord and consult
your dealer before
operating
any further.
• If you are not going to operate the System for an extended
period of time, unplug the AC power cord from the wall
outlet.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
HOW to B:;ead ! his Mahual:::
::;;:
To nmke the explanations
in this nmnual
as simple and easy-
to-understand
as possible,
we have adapted
the following
methods:
• Button and control operations
are explained
as listed in the
table below. In this manual,
the operations
using tile
remote
control
is nminly explained;
however,
you can use
the buttons
and controls
on flae main unit if they have tile
same (or similar)
name and nmrks.
• Some related
tips and notes are explained
later in the
sections
"Learning
More
about
This System"
and
"Troubleshooting,"
but not in the same
section
explaining
the operations.
If you want to know more about
the functions,
or if you have a doubt about the function,
go
to these sections
and you will find your answer there.
Indicates
that you press the button
briefly.
Indicates
that you press the button
briefly
and repeatedly
until an
option
you want is selected.
Indicates
that you press one of the
buttons.
Indicates
that you press and hold tile
button
tbr a specified
period.
• The number
inside the arrow
indicates
the period of press (in this
example,
2 seconds).
• If no nmnber
is inside the arrow,
press and hold until the entire
procedure
is complete
or until you
get a result you want.
Indicates
that you turn tile control
toward
the specified
direction(s).
Indicates
that this operation
is only
possible
using tile remote
control.
Indicates
that this operation
is only
possible
using the buttons
and controls
on
tile main unit.
2
Advertisement
