Fault Codes - Frigidaire FAD504TDB0 Use & Care Manual

Electrolux
Table of Contents

Advertisement

Fault Codes
1. If the display reads "AS" or "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center.
HIGH
HUMIDITY
SETTING
RH%
BUCKET FULL
0
FILTERRESET
POWER
ON
LOW
Removing
Collected
Water
1. Emptying the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.
HIGH
HUMIDITY SETTING
0
BUCKET FULL
RH%
FILTERRESET
POWER
ON
LOW
b.
Do not move the unit at this point otherwise water may spill on the floor.
c.
Press sides of bucket gently to unclip the bucket from the unit.
d.
Remove the bucket as shown in the photographs below and empty the bucket.
[i
Discard water from bucket. Water is not potable and cannot be used for drinking.
e.
f.
Replace the empty bucket back into the unit and once seated correctly the unit will start up again.
You should hear a click when the bucket is in the correct position
02009
Electrolux Home Products, Inc.
All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents