Fault Codes - Frigidaire Dehumidifier Use & Care Manual

Operating Instructions
Operating Instructions
(continued)
NOTE:
1. Before entering TIMER setting, make sure power is being supplied to the unit.
2. Before entering TIMER setting, make sure pressing
CLEAN FILTER
8. To shut the unit down, press the ON/OFF button.
CLEAN FILTER

Fault Codes

1. If the display reads "F1", "F2", "F5", "L1", "C5" or "E5" error codes, please turn off and unplug the unit, then plug it
in again in 30 minutes. If the unit malfunctions still, please contact your Authorized Frigidaire Service Center.
CLEAN FILTER
2.If the display reads "F0" , check the following operating conditions. Outlet voltage should be 115V±10% and the
surrounding temperature should be with in the range of 41 °F (5 °C) to 90 °F (32 °C). Unplug the unit and plug it in
again under normal operating conditions. If the "F0" code persists, contact your Authorized Frigidaire Service Center.
CLEAN FILTER
2009 Electrolux Home Products, Inc.
6
LOCK HIGK
TIMER
MEDIUM
LOW
FILTER
FAN
TIMER
SPEED
LOCK HIGK
TIMER
MEDIUM
LOW
FILTER
FAN
TIMER
SPEED
LOCK HIGK
TIMER
MEDIUM
LOW
FILTER
FAN
TIMER
SPEED
LOCK HIGK
TIMER
MEDIUM
LOW
FILTER
FAN
TIMER
SPEED
+ -
or button sets one desired room humidity first.
SLEEPING SPACE
LIVING SPACE
BASEMENT
_
+
MODE
SLEEPING SPACE
LIVING SPACE
BASEMENT
_
+
MODE
SLEEPING SPACE
F1
LIVING SPACE
BASEMENT
_
+
MODE
SLEEPING SPACE
F0
LIVING SPACE
BASEMENT
_
+
MODE
BUCKET FULL POWER
CONTINUOUS
CONTI
NUOUS
BUCKET FULL
POWER
CONTINUOUS
CONTI
NUOUS
BUCKET FULL POWER
CONTINUOUS
CONTI
NUOUS
BUCKET FULL
POWER
CONTINUOUS
CONTI
NUOUS
All rights reserved.