Fault Codes - Frigidaire LAD704DUL Use & Care Manual

Operating Instructions
(continued)
6. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours.
If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is
off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start).
TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the A or V button to
change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The
control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the
fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER
button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either
starts or stops. Once that happens the above steps have to be repeated.
1. Before entering TIMER setting, make sure power is being supplied to the unit.
2. Before entering TIMER setting, make sure pressing HUMIDITY A or V button sets one desired room humidity first.
bucket full
clean jSlter R
I
fitter V A timer ON-OFF
Lhum_d_ty -j
hf
I
law
I
fan
speed
J
7. To shut the unit down, press the ON/OFF button.
bucket ,full
I
cleanj_lter low
i I
fitter fan
speed
V A timer
Lhum_d_tyJ
ON=OFF
J
Fault Codes
1. If the display reads "AS" or "ES", a sensor has failed. Contact your Authorized Frigidaire Service Center.
bucket fu!!
clean _lter
I
filter V A timer ON-OFF
Lhum_d_tyJ
hf
I
law
I
fan
speed
J
6 ©2009 E!ec!ro!ux Home Product% Inc: AH r!gh!s reserved.