Still Image Recording; Continuous Shooting - JVC GZ-MG30U Instructions Manual

28
EN STILL XFIAGERECORDXNG & PLAYBACK
| Still ImageRecording
Power Switch
Lock Button
MODE
Re g Start]Stop
Button
1
Set the power sw tch to
2 Set the MODE switch to _.
• The camera is programmed to record still images
on the built-in hard disk by the factory-preset. To
switch the recording medium, see pages 21,48
and 49.
• To change the picture quality, see pages 48 and
51.
• To use the light, see page 31.
3 Press the recording start/stop button. PHOTO
indicator appears during shooting. The still
image is recorded.
• To check how the image looks before recording,
press the recording start/stop button halfway and
hold. The ,_e indicator appears and stops blinking
when the captured image is focused. To cancel
the recording, release the recording start/stop
button. To record it on the recording medium.
press the recording start/stop button fully.
NOTES:
• There may be differences in the brightness
between the recorded video and still image, even
if the same subject is shot.
• To turn the shutter sound off, see page 48.
• For approximate number of storable images, see
page 63.
Zooming
Use the zoom function for close-up or wide-
angle shooting. For details, see page 23.
Continuous Shooting
If tile continuous shooting mode is set to oil,
keeping the recording start/stop button pressed
in step 3 in "Still Image Recording" ( pg. 28)
provides an effect similar to serial photography.
(Interval between still images: approx. 0.5
seconds)
To use this function, set the [CONTINUOUS
SHOOTING] to [ON]. ( pg. 51) The
indicator appears on the display.
• To turn off this function, set ]CONTINUOUS
SHOOTING] to [OFF].
• Continuous shooting may not work well depending
on the recording medium.
• The continuous shooting speed will drop when
repeatedly making continuous shots.
Deleting Files
If you press "@ during recording mode, the file
recorded most recently will be deleted.
( pg. 39)
• However, if the recording mode (video or still
image) is switched or the power is turned off and
on again after recording, you cannot delete the
file.