Changing The Menu Settings; Common Menus For All Modes; Basic Setting; Operation Sound - JVC GZ-MG30U Instructions Manual

48
EN MENU SETTINGS
I Changing the MenuSettings
You can change the menu settings to customize
your camera. Access the desired menu screen
by following the steps below, then change the
various settings.
| Common Menus for AllModes
[ ] = Factory-preset
_ BASIC SETTING
I",l;1:[-']:l i
_ ower Switch
Lock Button
EXECUTE: Resets all settings to the factory-
preset.
[CANCEL]: Returns to the menu screen without
executing reset.
ID] = hVj [o] Lvj [o]D]=11
< v >
1 Select the operation mode.
For Recording Menus:
Set the power switch to [oJ.
For Playback Menus:
Set the power switch to [_l.
2 Select _ (video) or l_'_ (still image) using the
MODE switch.
3 Press MENU. The menu screen appears.
4 Select the desired sub menu and menu item
with A/v and I_11.
• To return to the normal screen, press MENU.
• To display the operation guide, press INFO/_
when the menu screen is displayed. (The
operation guide is not displayed depending on the
type of the menu.) To remove the operation guide,
press INFO/ai again.
• Even if the menu item is displayed, some item
cannot be set depending on the selected mode
(video/still image, recording/playback), In this
case, sub menu cannot be accessed or setting
cannot be changed.
OFF: Disables the function.
[ON]: Activates demonstration mode and shows
various features on the display.
Demonstration starts in the following cases:
• When the menu screen is closed after [DEMO
MODE] is set to [ON],
• With [DEMO MODE] set to [ON], if there is no
operation for about 3 minutes after the power
switch is set to _.
• Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume,
NOTES:
• Demonstration only works with DC cord
connected, not with battery.
• If an SD card is in the camera, demonstration will
not take place even if it is set to [ON].
• [DEMO MODE] remains [ON] even if the camera
power is turned off.
OFF: Turns off operation sound.
BEEP: The beep sounds when the power is
turned on or off, and at the beginning and end of
recording.
[MELODY]: Instead of a beep, a melody sounds
when any operation is performed.