Removing And Replacing The Oven Door; Changing Oven Light - Frigidaire CGEB27Z7HS3 Use & Care Manual

REMOVING AND REPLACING THE OVEN
DOOR
CHANGING OVEN LIGHT
The door is heaw. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
To Remove Oven Door:
1. Pull the door open.
2. While supporting the door with one hand, remove the
2 screws securing the top hinge to the door.
3. Remove the top hinge, then lift up the door to clear
the lower hinge pin and remove the door.
To Replace Oven Door:
1. Insert the door into the lower hinge.
2. Replace the top hinge and secure it to the door with
the 2 screws.
Special Door Care Instructions - Most oven doors
contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks
are fully in place.
2. Do not hit the glass with pots, pans, or any other
object.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
On some models an interior oven light will turn on
automatically when the oven is opened. The oven light
may be turned on when the door is closed by using the
oven light switch located on the Electronic Oven control.
The oven light bulb is covered with a glass shield held
in place by a wire holder. THIS GLASS SHIELD MUST
ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN I SCOOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against
.
4.
possible broken glass.
Replace bulb with a 40 Watt appliance bulb only.
For self-cleaning oven, press wire holder to one side to
release glass shield, change bulb
and be sure to replace glass shield.