Adjustable Racks; Removing The Upper And Middle Racks - Jenn-Air JDB1250AWW Use & Care Manual

Adjustabme Racks (select models:}
The Adjustable Upper Rack (select models) and
Adjustable Middle Rack can be raised or lowered to
accommodate taller plates, platters, pans, etc. in the
upper, middle or lower racks. Full size dinner plates
can be loaded in the upper rack if it is in the lower
position. The rack is easier to adjust before it is fully
loaded.
To mower the rack: Adjusters
1. Pull the rack
fully out.
2. Place thumbs
on each lever
on the adjuster
while holding
rack with
hands.
3. Press down on the levers with thumbs and push
rack down. The rack will come to a stop when it is
in position.
To raise the rack:
1. Pull the rack fully out.
2. Place hands on both sides and lift up until rack
comes to a stop and latches in place.
. The dishwasher will not
operate correctly if the
rack wash arm
connection is not aligned
with one of the water
inlet holes on hack wall
of the dishwasher.
. The left and right side adjusters on the racks
must both be fully in the upward or downward
position for proper connection.
Removing the Upper
and Middle Racks
The racks can be removed when tall or oversized items
need to be loaded into the middle or lower rack.
Unload the rack before removing it from the dishwasher.
To remove rack with push tab rack stops (select
models):
1. Roll the rack '/._ to '/_of the way out.
2.
To remove each plastic push tab rack stop from
the end of each track, push inward (toward the
rack) on the ridged area of the rack stop. The rack
stop will snap open and can be easily removed by
pulling straight
out. Take care to
support the track
while removing
rack stops.
3. Roll the rack all
the way out of
the track and
remove from the
dishwasher.
To replace:
Push Tab
Rack Stop
. Reverse the above procedure to replace the rack into
the dishwasher.
To remove rack with pull tab rack stops (select
models):
1.
2.
.
Roll the rack '/._ to '/_of the way out.
To remove each plastic pull tab rack stop from the
end of each track, locate two-prong tab on inside
of the rail and pull tab out toward rack. The rack
stop can then be easily removed by pulling it
straight out. Take care to support the track while
removing the
rack stops.
Roll the rack all
the way out of
the track and
remove from the
dishwasher.
To replace:
. Reverse the above
procedure to
replace the rack
into the dishwasher.
Pull Tab
Stop