Installation Instructions; Tools And Parts; Custom Overlay Frame - Jenn-Air JUB248LBCX00 Use & Care Manual

INSTALLATION INSTRUCTIONS
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
• Hand drill or electric drill • Scissors
(properly grounded) • Masking tape
• _/2"Brad point doweling
drill bit • Tape measure
• Phillips screwdriver • Petroleum jelly
PARTS NEEDED:
Custom Overlay Frame--See "Overlay Frame--Rear View."
Hardware (Optional)
PARTS SUPPLIED:
• Flat-head screws (8) • Overlay plates (2)
• Round-head screws (8) • Overlay hooks (4)
If you plan to install a custom overlay frame, you will need to
create the frame yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for frame specifications.
IMPORTANT:
• The thickness of the overlay frame must be 3/4" (1.91 cm).
• Overlay frame must not weigh more than 10 Ibs (4.54 kg).
• Overlay frames weighing more than recommended may
cause damage to your appliance.
Overlay Frame-- Rear View
Create the custom overlay frame using the dimensions shown.
A
15_6 ''
(3.33 crn)
413/32" 2.95"
(11.2 cm) (7.6 cm)
2.95"
(7.5 era)
(6.4 cm)
23.62"
(60.0 cm)
A. Overlay hook locations
297/8 ''
(76.66 cm)
Install Overlay Hooks
Using a Phillips screwdriver and eight flat-head screws attach the
overlay hooks to the back of the overlay frame. See "Overlay
Frame-Rear View" for overlay hook locations.
A. Overlay hooks (4)
Door Hinge Holes
• The views of the top and bottom hinge pin hole show a right-
hand hinge. Mirror the image for a left-hand hinge.
• We recommend using a C-Clamp and two pieces of scrap
wood (front and back) to help reinforce the overlay frame
when drilling the hinge pin holes.
Using a V_" Brad point doweling drill bit, drill a _/_"(1.27 cm)
deep hole into the top of the overlay frame for the top hinge
pin as shown.
Top View
Front Surface
Back Surface
A. Radius 5.0