Dryer Care - Inglis IV87001 User Instructions

Table of Contents

Advertisement

Available languages

Available languages

2.
3.
Put wet items on top of rack, leaving space between items.
Do not allow items to hang over the edge of the rack. Close
the door.
Select a timed drying cycle and temperature,
or an air cycle.
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using an air cycle. Refer to the following
table.
4. Start the dryer. Reset cycle to complete drying, if needed.
Rack Dry
Cycle
Temp
Time
Washable wool items (block
Timed
Low
60 min.
to shape, lay flat on rack)
Dry
Stuffed toys/pillows
(cotton
Timed
Low
60 min.
or polyester filled)
Dry
Stuffed toys/pillows
Air Dry
N/A
90 min.
Foam rubber filled
(no heat)
DRYER CARE
-,'......................
u,,.............
IF,_ [(:),_ _,0(;:;:4 ( ,_;_
Keep dryer area clear and free from items that would obstruct the
flow of combustion
and ventilation
air.
Explosion Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage instalation.
Failure to do so can result in death, explosion,
or fire.
_.,
-
.....
;'-4
"
Clean lint screen before each load. A screen blocked by lint can
increase drying time.
IM PORTANT:
Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint.
Every Load Cleaning
1. The lint screen is located on the top of the dryer. Pull the lint
screen toward you. Roll lint off the screen with your fingers.
Do not rinse or wash screen to remove lint. Wet lint is hard to
remove.
2. Push the lint screen firmly back into place.
As Needed Cleaning
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen
in dryer.
1=
Apply a liquid, nonflammable household cleaner to the stained
area of the drum and rub with a soft cloth until stain is
removed.
2. Wipe drum thoroughly with a damp cloth.
3. Tumble a load of clean cloths or towels to dry the drum.
NOTE: Garments which contain unstable dyes, such as denim
blue jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not
stain future loads of clothes. Dry unstable dye items inside out to
avoid transfer of dye.
From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending
on dryer usage. Cleaning should be done by a qualified person.
From Inside the Exhaust Vent
Lint should be removed every 2 years, or more often, depending
on dryer usage.
Vacation care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time,
you should:
1. Unplug dryer or disconnect power.
2. If you have a gas dryer, close shutoff valve in gas supply line.
3. Clean lint screen. See "Cleaning the Lint Screen."
Moving care - Electric Dryers
For power supply cord-connected
dryers:
1. Unplug the power supply cord.
2. Make sure leveling legs are secure in dryer base.
3. Use masking tape to secure dryer door.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Iv87000Iv86001

Table of Contents