Light Operation - Kenmore 415.23665310 Use & Care Manual

Grill Halogen Lighf
LIGHT OPERATION iNSTRUCTiONS
1. Make sure light switch on the control panel is in the "OFF" position
2. Connect light plug to an extension cord, then put the extension
cord plug into the outlet on the wall.
3. Turn the light switch to "ON"
° Keep any electrical supply cord away from any
heated surface.
• Use the shortest length extension cord required.
Do not connect 2 or more extension cords together.
Light
2. 3.
cord,
for out door use
Bulb Replacement
Make sure light switch on the control panel is in the "OFF" position and adapter plug is disconnected from outlet.
Release the screw securing the light
socket.
Take out the socket and remove the lens.
Loosen the two screws which are
locking the bulb.
Pull out the bulb and replace
with a new bulb.
16 _ 464225913
Reverse instructions from step 3
through step 1 to re-install socket.
Remark: skip step 3 if there is no screw
locking the bulb.
Take care not to touch the bulb with your bare fingers.
Touching bulb with your skin can leave a film on the
bulb that causes it to burn out quickly.
Bulb Specification
Bulb Type: Halogen
Wattage: 10 W per bulb
Voltage: 12 V
Continued on next page