Light Bulb Replacement - Kenmore 600 Series Manual

Light Bulb Replacement

If the light bulbs on the inside rear of the firebox do not work, follow the steps below to replace them.
It is recommended to remove the grill lid before attempting to replace the firebox light bulbs. Open the lid and remove the
cotter keys from each hinge bolt. Unscrew the hinge bolt from the nut on each side. Lift off the lid. Replace lid when finished
replacing bulbs.
Do not touch the replacement bulb at any time with your bare fingers. Perspiration residue from your skin may dry on the
bulb surface and cause it to burn out prematurely.
CAUTION: Be careful with fingers around possible sharp edges of the firebox when changing bulbs.
1. Remove the screw and nut holding the bulb case in place.
CAUTION: Be careful with fingers around possible sharp edges
when removing bulb case screws and nut.
2. Remove the bulb case from the light fixture.
3. Press button on end of bulb case to free
and remove bulb case glass
4. Wiggle the old bulb free from the bulb socket.
16
5. Using a glove or cloth, insert new bulb into bulb
6. Reinstall the bulb case glass onto the bulb case
7. Fit the bulb case back into the light fixture.
8. Tighten the bulb case back into place with
previously removed screw and cut.
CAUTION: Be careful with fingers around
possible sharp edges when replacing bulb case
screw and nut.
socket.
.