Advertisement
SERVICE AND ADJUSTMENTS
_
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
• Depress brake pedaJ fully and set parking brake.
•
Place attachmentclutch
in
DISENGAGED
position.
• Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE
MOWER
(See Fig, 17)
Place attachment clutch in "DISENGAGED"
position.
Lower attachment lift lever to its lowest position.
Remove mower belt from engine pulley (M).
Remove retainer spring (K), slide collar (L) off and push
housing guide (P) out of bracket.
Remove clutch cable spring (Q) from idler arm (R).
Disconnect front link (E) from mower - remove retainer
spring and washer.
Go to either side of mower and disconnect
mower
suspension arm (A) from chassis and rear lift link (0)
from rear mower bracket (D) - remove retainer springs
and washers.
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER
IS TO BE MOUNTED
ON THE TRACTOR,
REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS
(C) FROM TRACTOR AND HOOKTHE CLUTCH SPRING
(Q) INTO THE CABLE GUIDE ON FRONT EDGE OF
LOWER DASH.
TO iNSTALL
MOWER
(See Figs. 17-22)
Be sure tractor is on level surface and engage parking
brake.
Lower attachment lift lever to it's lowest position.
I
A
CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
CAUTION: After rear lift links are dis-
connected,
the attachment
lift lever
will be spring loaded. Have a tight grip
on lift lever when changing
position of
the lever.
Slide mower out fro m under fight Side Of tracto[. (
NOTE: Be sure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
Slide mower under tractor until it is centered under
tractor.
Fig. 17
03042
18
Advertisement
