Advertisement
OPERATION
TO OPERATE
MOWER
(See Fig. 10)
Your tractor is equipped with an operator presence sensing
switch. Any attempt by the operator to leave the seat with
the engine running and the attachment clutch engaged will
shut off the engine. You must remain fully and centrally
positioned in the seat to prevent the engine from hesitat-
ing or cutting off when operating your equipment on rough,
rolling terrain or hills.
1.
Select desired height of cut with attachment lift lever.
2.
Start mower blades by engaging attachment
clutch
control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
I
Donot ope
the mower
I
A_.
without eithertheentiregrasscatcher,
I
_
o_ipped,
or the deflec-
tor shield (S) in place.
Fig. 10
REVERSE
OPERATION
SYSTEM
(ROS)
Your tractor is equipped with a Reverse Operation System
(ROS). Any attempt by the operator to travel in the reverse
direction with the attachment clutch engaged wilt shut off the
engine unless ignition key is placed in the ROS "ON" position.
Ai:_WARNING: Backing up with the attachment clutch en-
gaged while mowing is strongly discouraged. Turning the
ROS "ON", to allow reverse operation with the attachment
clutch engaged, should only be done when the operator
decides it is necessary to reposition the machine with the
attachment
engaged.
Do not mow in reverse
unless
absolutely
necessary,
USING THE REVERSE OPERATION SYSTEM -
Only use if you are certain no children or other bystanders
will enter the mowing area.
Depress brake pedal all the way down.
With engine running, turn ignition key counterclockwise
to ROS "ON" position.
Look down and behind before and while backing.
Slowly depress reverse drive pedal to start movement.
When use of the ROS is no longer needed, turn the
ignition key clockwise to engine "ON" position.
TO OPERATE
ON HILLS
I
_
CAUTION: Donotdriveupordownhills
I
|_
with slopes greater than 15 ° and do not
I
drive across any slope.
Choose the slowest speed before starting up or down
hills.
Avoid stopping or changing speed on hills.
If stopping is absolutely necessary, push brake pedal
quickly to brake position and engage parking brake,
To restart movement, slowly release parking brake and
brake pedal,
Slowly depress appropriate drive pedal to slowest set-
ting.
Make all turns slowly',
TO TRANSPORT
(See Figs.
3 and
11)
When pushing or towing your tractor, be sure to disengage
transmission by placing freewheel control in freewheeling
position. Free wheel control is located at the rear drawbar
of tractor.
Raise attachment lift to highest position with attachment
lift control.
Pull freewheel control out and down into the slot and
release so it is held in the disengaged position.
Do not
push or tow tractor at more than two (2)
MPH.
To reengage transmission, reverse above procedure.
NOTE:
To protect hood from damage when transporting
your tractor on a truck or a trailer, be sure hood is closed
and secured to tractor. Use an appropriate means of tying
hood to tractor (rope, cord, etc.).
TRANSMISSION
ENGAGED
TRANSMISSION
DISENGAGED
Fig. 11
ROS "ON" POSITION
ENGINE "ON" POSITION
(NORMAL
OPERATING)
11
Advertisement
