Storing; Preparing For Use After Storage - Husky HU80931 Operator's Manual

STORING THE PRESSURE WASHER
It is important to store this product in a frost-free area. Always
empty water from all hoses, the pump, and the detergent
bucket before storing.
NOTE: Use of a fuel stabilizer and pump saver will give you
better performance and increase the life of the machine.
Discharge Fuel:
Drain the fuel tank completely. Stored gas can go stale in
30 days.
Engine Oil:
Drain the oil and replace with fresh, clean oil.
Spark Plug:
[] Disconnect spark plug wire and remove the spark plug.
Pour about a teaspoon of clean, air-cooled, four-cycle
oil through the spark plug hole into the combustion
chamber.
[] Leaving the spark plug out, pull the starter cord two or
three times to coat the inside of the cylinder wall.
[] Inspect the spark plug and clean or replace, as neces-
sary.
[] Reinstall the spark plug, but leave the spark plug wire
disconnected.
Air Filter:
[] Clean the air filter.
Hoses and Pump:
Flush the injection hose with clean water for 1-2 minutes.
Remove all hoses. Empty the pump by pulling on the recoil
starter about 6 times. This should remove most of the liquid
from the pump.
PREPARING FOR USE AFTER STORAGE
[] Pull the recoil starter grip three or four times to clean oil
from the combustion chamber.
[] Remove spark plug from the cylinder. Wipe oil from the
spark plug and return it to the cylinder.
[] Reconnect the spark plug wire.
[] Refuel the machine as described earlier in the operator's
manual.
18