Table of Contents
Advertisement
I
CONNECTING
THE HiGH PRESSURE
HOSE TO
THE PUMP
See Figure 9.
After the high pressure hose has been uncoiled and attached
to the spray wand:
• Align the collar on the threaded nipple on the pump.
•
Insert the nozzle on the end of the high pressure hose
collar into the threaded nipple.
• Turn the collar clockwise to tighten the hose securely to
the pump.
•
Pull on the hose to be certain it is properly secured.
CONNECTING
THE GARDEN
HOSE
TO THE
PRESSURE
WASHER
See Figure 10.
The water supply must come from a water main. NEVER
use hot water or water from pools, lakes, etc. Before
connecting the garden hose to the pressure washer:
•
Run water through the hose for 30 seconds to clean any
debris from the hose.
•
Inspect the screen in the water intake.
•
If the screen is damaged, do not use the machine until
the screen has been replaced.
•
If the screen is dirty, clean it before connecting the garden
hose to the machine.
To connect the garden hose to the machine:
•
Uncoil the garden hose.
NOTE:
There
must
be a minimum
of 10 feet
of
unrestricted hose between the pressure washer intake and
the hose faucet or shut off valve (such as a "Y" shut off
connector).
• With the hose faucet turned completely
off, attach the
end of the garden hose to the water intake. Tighten by
hand.
COLLAR
Fig. 9
WATER
INTAKE
GARDEN
HOSE
Fig. 10
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
_IL
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating
tools.
Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments
or accessories not recom-
mended
by the manufacturer
of this tool. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Do not direct discharge stream at persons. Failure to heed
12
Hide quick links:
Advertisement
Table of Contents
