Adding Oil To The Engine; Adding Gasoline To The Fuel Tank - Husky HU80931 Operator's Manual

ADDING OiL TO THE ENGINE
See Figure 4.
NOTE: This machine has been shipped with approximately
2 oz. of oil in the engine from testing. You must add oil to
the engine before starting it the first time.
| Any a!tempt to s!art the engine without adding oil will
result in engine failure.
[] Place pressure washer on a flat, level surface.
[] Unscrew the oil cap/dipstick by turning counter-
clockwise.
[] Using 4-stroke engine oil (SAE 30), fill to the upper level of
the oil filter neck (18 oz., 4-cycle engine oil provided).
[] Replace the oil cap/dipstick and securely tighten.
NOTE: This engine has a total oil capacity of 20 oz.
(.6 liters).
ADDING GASOLINE TO THE FUEL TANK
See Figure 5.
,_ WARNING:
Gasoline and its vapors are highly flammable and
explosive. To prevent serious personal injury and property
damage, handle gasoline with care. Keep away from
ignition sources, handle outdoors only, do not smoke
while adding fuel, and wipe up spills immediately.
When adding gas to the pressure washer, make sure the unit
is sitting on a flat, level surface. If the engine is hot, let the
pressure washer cool before adding gas. ALWAYS fill the
fuel tank outdoors with the machine turned off.
NOTE: Use unleaded gas only. DO NOT mix oil with gas.
[] Before removing the fuel cap, clean the area around it.
Remove the fuel cap.
[] Insert a clean funnel into the fuel tank then slowly
pour gasoline into the tank. Fill tank to approximately
1-1/2 in. below the top of the tank neck (this allows for
fuel expansion).
[] Replace fuel cap and tighten securely.
[] Clean up any spills before starting the engine.
01L CAP/
DIPSTICK
FUNNEL
FUEL
CAP
Fig. 4
Fig. 5
10