Advertisement
SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place motion control lever in neutral (N) position.
•
Place attachment clutch in "DISENGAGED"
position.
•
Turn ignition key "OFF" and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE
MOWER
(See Fig. 23)
•
Place attachment clutch in "DISENGAGED" position.
•
Turn height adjustment knob to lowest setting.
•
Lower mower to its lowest position.
•
Remove retainer spring holding anti-swaybar to chas-
sis bracket and disengage anti-swaybar from bracket.
•
Remove retainer springs from suspension
arms at
deck and disengage arms from deck.
•
Raise attachment lift to its highest position.
•
Remove two retainer springs from each front link and
remove links.
•
Slide mower forward and remove belt from electric
clutch pulley.
•
Slide mower out from under right side of tractor.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
TO INSTALL
MOWER
Follow procedure described in "INSTALL MOWER AND
DRIVE BELT" in the Assembly section of this manual.
TO LEVEL MOWER
HOUSING
Adjust the mower while tractor is parked on level ground or
driveway.
Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" section of this manual). If
tires are over or underinflated, you will not properly adjust
your mower.
SIDE-TO-SIDE ADJUSTMENT
(See Figs. 24 and 25)
•
Raise mower to its highest position.
•
Atthe midpoint of both sides of mower, measure height
from bottom edge of mower to ground. Distance "A" on
both sides of mower should be the same or within 1/4"
of each other.
•
If adjustment is necessary, make adjustment on one
side of mower only.
•
To raise one side of mower, tighten lift link adjustment
nut on that side.
•
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Three full turns of adjustment
nut will change
mower height about 1/8".
•
Recheck measurements after adjusting.
BOTTOM
EDGE
BOTTOM
EDGE
OF MOWER TO
OF MOWER
TO
GROUN___.
.
GROUND
GROUND
LINE
FIG. 24
NUT
CHASSIS
ARMS
ADJUSTMENT
NUTS
LIFT
LINKS
FRONT
MOWER
BRACKET
FRONT
I-I_. Zb
RETAINER
ANTI-SWAY
RETAINER
SPRINGS
FIG. 23
,RETAINER
SPRINGS
MOWER
BRACKET
?
21
Advertisement
Troubleshooting
