To Remove Mower; To Install Mower; Service And Adjustments - Husqvarna YTH2348 Owner's Manual

SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS iNJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST-
MENTS:
Depress brake pedal fully and set parking brake.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
Diseonnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE MOWER (See Fig. 17)
Place attachment clutch in "DISENGAGED" position.
Lower attachment lift lever to its lowest position.
Disengage belt tension rod (K) from lock bracket (L).
[_1_ CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rodand
release slowly.
Remove mower belt from electric clutch pulley (M).
Disconnect front link (E) from mower - remove retainer
spring and washer.
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (O)
from rear mower bracket (D) - remove retainer springs
and washers.
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
CAUTION: After rear lift links are dis-
connected, the attachment lift lever
will be spring loaded. Have a tight grip
on lift lever when changing position of
the lever.
From right side of mower, disconnect anti-sway bar (S)
from right rear mower bracket (D) - remove retainer
spring and washer and pull mower toward you until the
bar falls from the hole in bracket.
Turn tractor steering wheel to the left as far as it will
go.
Slide mower out from under right side of tractor.
TO iNSTALL MOWER (See Figs, 17-21)
Be sure tractor is on level surface and engage parking
brake.
Lower attachment lift lever to it's lowest position,
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position,
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right.
FIG. 17
18