Table of Contents
Advertisement
Available languages
Available languages
SERVICE AND ADJUSTMENTS
CAUTION:
Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST
HANDLE
HEIGHT
(See Fig. 15)
Factory assembly
has provided
lowest handle height.
Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil.
•
If a higher handle height is desired, loosen the four
nuts securing handle panel to engine brackets.
Slide handle panel to desired location.
Tighten the four nuts securely.
ENGINE
BRACKETS
HANDLE
/I
PANEL
NUTS (ALSO 2
ON LEFT SIDE
OF TILLER)
Fig. 15
TINE ARRANGEMENT
Your outer tines can be assembled in several different ways
to suit your tilling or cultivating needs.
CAUTION: Tines are sharp. Wear gloves
or other protection when handling tines.
NORMAL TILLING =26" PATH (See Fig. 16)
*
Assemble holes "A" in tine hubs to holes "B" in tine
shaft.
MID=WIDTH TILLING - 24" PATH (See Fig. 17)
*
Assemble holes "A" in tine hubs to holes "C" in tine
shaft.
A
C
C
A
[o_
6o]
Fig. 17
NARROW TILLING/CULTIVATING
- 12-3/4" PATH (See
Fig. 18)
*
Remove outer tines.
OII
I IO
INNER TINES ONLY
ool
tine
6
Fig. 18
NOTE: When reassembling outer tines, be sure right tine
assembly (marked "R") and left tine assembly (marked
"Z') are mounted to correct side of tine shaft.
CLEVIS
OUTER
i_'_
PIN
TINE
....
HAIRPIN
CLIP
INNER TINE
Fig. 16
13
Advertisement
Table of Contents
