Hitachi 42HDS69 Operating Manual page 58

58
CableCARD Information
After the CableCARD has been successfully installed,
you can access CableOARD Information menu in the
SETUP menu of the On-Screen Display.
Follow the instructions below to access the CableCARD
Information menu.
1. Press the MENU button on the Remote Control to
access the Main Menu screen.
2. Use the CURSOR PAD _1'to highlight SETUP in
the Main Menu and press the SELECT button.
3. Use the CURSOR PAD T to highlight CableCARD
Information and press the SELECT button.
4. To view the CabieCARD ID and Host ID, use the
CURSOR PAD I' to highlight CableCARD Info and
press the SELECT button.
THINGS TO CHECK WHEN USING THE
CableCARD / CableCARD Services
1. Check that the CableCARO is properly inserted in
the CableCARD slot.
2. Remove the CableCARD by pressing
and pulling the CableCARD straight out.
3. Visually inspect the CableCARD to ensure all pin-
holes are in good condition, with none blocked or
damaged.
4. Make sure the CableCARD is re-inserted in the
correct direction, then slowly push until it is fully
seated in the slot.
5,
When the CableCARD is installed, note all screen
messages that appear ("CableOARD Installed",
"Acquiring Data", "CableCARD is not Installed").
If the "CableCARD Installed" message does not
appear when card is installed, check the TV's card
slot and CableCARD pins for obstructions or
damage.
6. If problems still remain, please contact your Cable
Service Provider.