Installation Instruc_Tions; Anti-Tip Bracket; Tools You Will Need - GE RA620 Owner's Manual And Installation Instructions

Installation Instructions
PREPARE TO INSTALL THE RANGE
MATERIALS YOU MAY NEED
Tin Snips Lag Bolts Anchor Sleeves
(For Anti-Tip Bracket Mounted on Concrete Floors Only)
(UL Approved 40 AMP)
4-Wire Cord OR 3-Wire Cord
4' Long 4' Long
Squeeze Connector
(For Conduit
Installations Only)
TOOLS YOU WILL NEED
Drill with 1/8" Bit Safety Glasses
Adjustable Wrench
Tape Measure
Pliers
Grr¢:
Pencil
1/4" Nut Driver Level
Phillips Screwdriver
Flat-blade
Screwdriver
PARTS INCLUDED
Anti-Tip Bracket Kit
Ill REMOVE SHIPPING MATERIALS
Remove packaging materials. Failure to
remove packaging materials could result
in damage to the appliance.
14
_-I PREPARE THE OPENING
• See the illustration below for all rough-in and
spacing dimensions. These dimensions must
be met for safe use of your range.
• The range may be placed with 0" clearance
at the back wall and 2" minimum clearance at
side walls of the range if the front edges of the
range side panels protrude beyond the cabinet
fronts at least 1/4".
• To eliminate the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can be
reduced by installing a range hood that
protrudes at least 5" beyond the front of the
cabinets. Cabinets installed above a cooktop
may be no deeper than 13".
From combustible
walls above cooking
surface
_4t_C 26" from
wall to front of
36" max.
Surface
mout_t
outlet
D (depl
with door \
open)
C
Models A B recommended) D
20" Wide 20" 20%" 2" 393/8,,
24" Wide 24" 243/8" 2" 40_& "
Flooring under the range
Your range, like many other household items,
is heaw and can settle into soft floor coverings
such as cushioned vinyl or carpeting.
When moving the range on this type of
flooring, it should be installed on a 1/4"
thick sheet of plywood (or similar material)
as follows:
When the floor covering ends at the front
of the range, the area that the range will
rest on should be built up with plywood
to the same level or higher than the floor
covering. This will allow the range to be
moved for cleaning or servicing.