Advertisement
THE BRUSHES
When brushes are worn and bristles do not
touch the edge of a card held across the
nozzle,
they
should
be replaced.
Always
replace both brushes at the same time to
maintain
cleaning
efficiency.
TO
REPLACE
THE
BRUSHES
1. (Disconnect
the Cleaner
from
Electrical
Outlet)
before
replacing
brushes.
2. To replace
worn brushes,
remove
bottom
plate,
belt and agitator,
following
directions
given
on Page 11. Turn end
plate of agitator
in opposite
direction
until one plate comes
off.
3. Then pry out end section.
4. After end section
is removed,
tap the
shaft
gently
with
a hammer.
5. Pull shaft
from
agitator.
6. Remove
brushes
by forcing
out with
screwdriver.
Replace
with
new brushes.
Slide them into the channel
and push in
as far as possible.
7. Replace
shaft,
lining up the Iocator
on
shaft with slot on the agitator.
Replace
other end section
and end plate and
tighten.
Replace
agitator
in cleaner.
(See
Page 12.)
13
Advertisement
