Hoover UH40110 Owner's Manual page 17

PROBLEM
Cleaner hard to
_ush
Cleaning tools
Visible dirt
leaking through
final filter
Dirt inside dirt
cup stops
spinning
Powered hand
tool brush roll
won't turn
POSSIBLECAUSE
Incorrect carpet height set-
ting
Blockage in hose
Low cleaner suction
Clearing blockages
Disconnect H eanerfrom electrical outlet.
Low suction or pick up may be due to a
blockage in the system, Refer to the follow-
ing steps to check for blockages continuing
with each step until the blockage is found:
A. If a blockage occurs during floor cleaning:
Turn cleaner OFF and disconnect from elec-
trical outlet.
1. Check fullness of dirt cup and filter
assembly; empty cup and clean filters if
needed.
Check dirt duet
2. Remove dirt cup,
look in duct [A).
3. Clear blockage
from dirt duct.
17
POSSIBLE SOLUTION
Move nozzle control knob to a higher set-
ting
Clear blockage,
Note: Heavy debris may settle to the bot-
tom of the dirt cup and prevent the dirt
from spinning without affecting cleaning
performance. The cleaner can continue
to be used even if the dirt is not spinning
inside the dirt cup.
However, if the dirt does stop spinning
AND there is a noticeable decrease of per-
formance, check the items under "Cleaner
Check items under "Cleaner won't
_
Check brush roll
4. Turn cleaner OFF
and unplug.
5. Turn cleaner over
and clear blockage
" from brush roll.
Return cleaner to
operating position.
Turn cleaner back
on and continue
cleaning.
Check hosetube
6. Turn cleanerOFF
and unplug.
7, Remove hose
from tube. Clear
blockage from
tube. Also, check
hose for blockage.