Hoover SteamVac F5835-900 Owner's Manual page 5

F_II0]
Storing hose
Stretch hose out and identify ends.
E. Nozzle connector end of hose G. Solution tube
F. Trigger H. Converter end of hose
Note: You may find it helpful when storing the hose to refer to the information on the
back of the deep cleaner and on the converter end of the hose.
Start with converter end of hose (H). Fit
converter over tab near tool holder (I).
Press converter firmly to snap in place.
Press solution tube (G) into clip next to
converter as shown.
IEP_
Wrap hose around hook on upper
handle (J). Press hose into clips on
upper hose holder (K).
Wrap hose around lower tool holder and
continue until nozzle connector is near
upper hose holder. Clip hose in place.
Press cord into cord clip on back of
hose holder. Pull cord tight.
Upfront tool storage
Powered hand tool
The powered hand tool is shipped in a
plastic bag for protection. Remove the
bag before using the tool by first open-
ing tool door.
To remove tool (A), pull it down and out-
ward.
To reposition the tool, reverse this proce-
dure.
How to reattach tool
cover
The tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
Continued -I,