GE TBX18SABKLAA Owner's Manual page 8

Aboutthefreshfoodcompartment s helves.
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
Half-Width Shelves
One end of the shellrests on a molded
side-wall support; a bracket on the other
end hooks into a track on the rear
cabinet wail.
To remove, lift the shell up at front, then
off the support and out of the track.
To replace, select desired shellheight.
With shellfront raised sfightly, hook the
bracket's top lug into the track, then
lower the shellonto the support.
NOTE:Theshelf to theright of the trackis
designedto hookinto the right-handslot,
the sheff to the left is designedto hook
into theleft-hand slot.
Full-14rtdthShelves
Some models have a steel wire sliding
shell, a stationary tempered glass shell or
two steel wire stationary shelves. These
shelves can be moved to another place in
the fresh food compartment.
The full-width sliding shelf has stop-locks.
When placed correctly on the shell
supports, the shellwill stop before coming
completely out of the refrigerator and will
not tilt when you place food on it or
remove food from it.
To remove the full-width shelves,lift the
rear of the shell and pull forward.
Toremove a full-width sheff when thefresh
foodcompartmentdoor cannothe opened
fully, lift the rear of the shell, pull forward
and down, tilt the shelland take it out.
8