GE PSS25NGNACC Owner's Manual And Installation page 5

About the temperaturecontrols.
The temperature controls are preset in the factory at 37°1: for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either orboth controlsto OFFstops coolingin both the freezer
and refrigerator compartments, but does not shutoff electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
TochatPge _ tem_tature, press and release the
WARMER or COI.tiERpad. The SETlight will come
on and the dLsplay will show the set temperatme,.
To chmlge the tempe, retiree, tap either the
WARMERor COLDER pad mltil the desired
temperature is displayed. Refrigerator temperatures
can be adjusted between _°I." and 44°F mid the
freezer tranperatur¢_, can be adjusted between
--6_F and
+6°E
Once the desined temperature has been set,
the temperature disphy will return to the actual
refrigerator and freezer temperatures ",d_er5
seconds. S¢.weral adjustments may be ix'quired.
Each time you adjust controls, all_v24 hours for the
rt_'rigerator to reach the temperatra'e you have set.
Toturn the cooling systemoff, tap the WARMER pad
for either the refrigerator or the freezer until the
ff_play shows 0/:E. To tam the _it back on, press the
COLDERpad for either tile refrigerator or freezer.
The SETlight will ilkuninate on file side you
selected. Then pros file COLBERpwd again (on the
side where the SB'light is illmniuated) and it ,Mll
go m the pr_-aet points of 0°Ffor the freezer and
37°E for the refrigerator. Setting either or both
controls m OR:stops coormg in both the freezer
and refrigerator compartments, but do_s not shrzt
offelectrical power to the refrigerator.
Performance Air FlowSystem
The Performance Air-Flow System is designed to
maximize temperattu:e control in the refiigerator
and freezer compartments. This tmiq_te special
feature cousists of the Air Tower along the back
wall of the refrigerator and the Air Tnnnel on the
bottom portion of the freezer rear wall. Placing food
in front of the louvers on these components will not
affect performance. Although the Air Tower and
the Air Tunnel can be removed, doing so will affect
temperature performance. (For removal
instrtmfious, on-line, 94 hours a day, contact us at
GEAppliances.com or call 800.GE.CARES. In
Canada, contact us at geappliances._ or call
1.800.361.3400.)
5