GE PSS25NGNACC Owner's Manual And Installation page 25

Installation Instructions
ROLLERS (CONT.)
To adjust the rollers on 23' models:
O Remove the base grille by opening the doors,
removing the screws at each end, and ptdling it
straight out.
Turn the tixmt roller _)
I II
0 adjusting scr_s
| IL_
clockwise to raise t I _
the refrigerator, _r"g_ rl_:::::x::_::::_
co.. o w e. 3 711
hex socket or v_Tench, -- "_],d
or an acljmtable
V,Tench. Roller adjusting s cr6ws
These models also have rear adjustable r_llers so you
can align the refrlgemtor with yottr kitchen cabinets.
Use a long-handled 5/16" ,socket v,Tench to turn the
screws for the rear rnllers-dockwlse to raise the
refrigerator, cotmterdockwise to lower it
Replace the base grille.
DOOR ALIGNMENT
After leveling, make sure that the refrigerator door is 1/16"
higher than the fi'eezer door.
To align the doors, adjust the refrigerator door.
Using a 7/16" socket wrench, turn the door adjmdng
screw to the right to raise the door, to the left to lower
it. (A nylon plug, imbedded in the threads of the pin,
prevents the pin from nlming unless a wrench ksusod.)
_ After one or two iaxrrts of die v,xench, open and clca,e
the refrigerator door and check the alignment at the
top of die doors.
Toremove thebase grille,
openthedoom. remove
thescrew at each e4",d of
thebasegdllemd then
pulJ f f_e grille straight out.
DIMENSIONS AND SPECIFICATIONS
(for CustomStyle" models)
o
o
(19me)Airspace
(1/2"[13ram] G ap +
1/4" 16 mm] W ailPlates)
J_ I
C0_p
25