Advertisement
After you plug in the unit it will perform a self test. All the display lights
wiJJturn on for 3 seconds. The LEDdisplay wiJJread "88". if any display
light fails to turn on you may need service on the unit. After the 3 seconds
self test the unit wiJJautomatically go to the stand by mode. Now aJJlights
,,viii be off and you will have to turn "ON" by pressing the On/Off
key.
After pressing "On/Off",
the unit starts to work and enters the status of
"Fan Only" with low setting. You wiJJhave to press the (+) or (o) key on the
Temp/Time to set the temperature at your desired comfort. You can choose
between 61 °F and 86°F. Once the temperature is set you can raise or
lower it by pressing the (+) or (-) keys. (Only when the unit is coding or
dehumidifying, can the temperature setting be adjusted.} (See Fig. # 2)
Fig. # 2
Control Pane|.
Having set the temperature you will set the function of the air conditionen
If you want to cod the room press the A/C function. Jfyou need to only
remove the moisture press the Dehumid function. If you just need to use the
fan only, press the Fan function. (See Fig. # 3}
g
Advertisement
