Removing The Generator; Blind End Cover Removal; Generator Isolation Mounts; Removing Stator Mounting Hardware - Briggs & Stratton 1938 Operator's Manual

&S_a_on
Service & Troubleshooting Guide ' Home Generator Systems
_ Model 1938 (I OkW) Generator Assembly
Removing The Generator
With the alternator bulkhead removed as shown in figure
60, you are ready to begin removal of the Meccalte-
Generator.
Blind End Cover Removal
• Remove the four screws holding the cover on the blind
end of the generator housing (Figure 61).
NOTE: Do attempt to loosen or remove the
hardware that attaches the isolation mounts to the
enclosure base.
Removing Stator Mounting Hardware
• Remove the cooling fan grids (Figure 63).
Generator Isolation Mounts
• Remove the nuts from the top of the isolation mounts
(Figure 62).
50