GE AZ75H12EACM1 Owner's Manual And Installation Instructions page 7

ge.com
Motion Sensor (Obtainedlocally)
Tile Occupancy Sensor dip switch nmst be ill
tile up position to use this teature.
\_]/en connected, the wall mounted motion
sensor will demct motion in the room and
autolnaficallv cycle tile unit between nomml
operation and energy inanagelnent operation.
Tile door and Inofion
sensoI_ work together
to automatically cycle the unit between nomml
operation and energy inanagelnent operation.
I I o o
L_ Motion Sensor
Door Sensor (Obtainedlocally)
The Occupancy Sensor dip switch must be in the
up position
to use this teatuI'e.
_]/en connected, tile door sensor will detect
when tile door ill tile room is opened or closed.
This ti_atuI'e n/ust be used in coqjunction with
tile
i/lotion sensoI:
The door
and
i/lotion sensoi3 work together
to auton/aticallv cycle the unit between mmnal
and enei'_ry,, i//anagei//ent, ol)ei'ations.
CentralDesk Control
\4lien connected, tile unit lock-out is released
and it can be turned ON or OFF with a switch
located at the (:entral Desk (;ontrol. A separate
wire pair must be run fl'om each separate
controlling switch to each individual Zoneline.
Remote Thermostat
The unit will be controlled by a rein ote
themlostat.
IMPORTAN7
Tile Zoneline themlostat cmmections
provide 24V AC only.
If using a digiml/elecmmic wall themlostat,
you inust set it to tile 24V AC setting. See tile
Installation Instructions tor tile wall themlostat.
A CAUTION:
Dalnage to a wall themlostat
or to tile
Zoneline electronics can result fl'Oln ilnproper
connections. Exercise extra attention when
connecting blue and black wires. No line
voltage connections should be inade to anv
drcuit ill tile d/elmostat. Isolate all wires ill
building fl'oln lille voltage.
Central Desk Control
cc_ -
Red-24V AC0nly
Green-LowSpeedFan
Green-HighSpeedFan
Black-Reversing Valve
Yellow-Compressor
White-Heater
Common-Ground