GE AZ75H12EACM1 Owner's Manual And Installation Instructions page 21

Installation Instructions
[] MAKE UNIT ELECTRICAL
CONNECTIONS
1.
Connect tile themlostat wires to tile unit and set
tile dip switches to tile appropriate settings.
NOTE: See the
Controls-Terminal C onnections
and Controls-Dip Switches sect.ions of this
mmmal and tile manual with tile separate
thellilOstat ti)i" proper connections
and settings.
Thermostat
]
--r
Unit Connections
Maximum Wiring
Length for Thermostat
Connection to the Unit
66 ft. for AW6 18
60 ft. for AW6 20
40 ft. for AW6 24
AWG AmericanWire Gauge
2. Make power connections to tile trait.
No'rE: See tile ELECTRICAL
REOUIREMENTS',md
DIRECT CONNECTAPPLICATIONS secdons,
as appropriate, ot this inanual for proper
connections.
3.
Replace tile case fl'ont panel b)' replacing tile four
Ji'ont
ScI'eWS }lll(l
tile two top scre_vs.
[] CONNECT THE TOP DUCT
1. Install tile duct onto tile air discharge outlet.
i!;i!;i!;i!;i!;i!;ii
i
Flexible or rigid
ducWvork _
'
Air f
discharge
outlet
2. Secm'e tile top duct to tile trait by tm'ning
tile fl)m"
case top duct a(!justing scre_vs tmtil they are tight.
Use a field supplied clamp to lock tile top dtlct to
tile case.
Casetop
duct adjusting
screws
Top duct
Clamp
21