Operation And Important Riding Points; Starting The Engine - Yamaha FJR13AEY Owner's Manual

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.

OPERATION AND IMPORTANT RIDING POINTS

EAU15951
TIP
This model is equipped with:
G
a lean angle sensor to stop the en-
gine in case of a turnover. In this
EWA10271
case, the multi-function display in-
dicates error code 30, but this is
not a malfunction. Turn the key to
"OFF" and then to "ON" to clear the
error code. Failing to do so will pre-
vent the engine from starting even
though the engine will crank when
pushing the start switch.
G
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. In this case,
the multi-function display indicates
error code 70, but this is not a mal-
function. Push the start switch to
clear the error code and to restart
the engine.
EAU46632

Starting the engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
G
G
Always apply the front or rear brake
while the main switch is in the "ON"
position and the transmission is in
gear, otherwise the rear wheel will
move freely.
1. Turn the key to "ON" and make
6-1
The front or rear brake is applied
with the transmission in the neutral
position whether the sidestand is
up or down.
The front or rear brake is applied
with the transmission in gear and
the sidestand is up.
See page 4-28 for more informa-
tion.
WARNING
sure that the engine stop switch is
set to " ".
The following warning lights and
indicators should come on for a
few seconds, then go off.
G
Oil level warning light
EAU40845
EWA14541
6