Shift Pedal - Yamaha FJR13AEY Owner's Manual

The hand shift control switch enables
shifting gears with the hand shift lever.
When the switch is set to enable hand
shifting, the hand shift control indicator
light will come on.
TIP
G
The shift pedal can be used to shift
gears whether the hand shift lever
is enabled or not.
G When the main switch is turned to
"OFF", the hand shifting mode will
automatically be disabled. Press
and release this switch after start-
ing the engine to enable hand
shifting.
INSTRUMENT AND CONTROL FUNCTIONS

Shift pedal

1. Shift pedal
This vehicle is equipped with a con-
stant-mesh 5-speed transmission. The
shift pedal is located on the left side of
the engine. Neutral is at the bottom po-
sition.
TIP
It is impossible to shift gears unless the
key is in the "ON" position.
The shift pedal can be adjusted to three
positions to suit the rider's preference.
To adjust the shift pedal position
1. Remove the shift pedal by remov-
ing the bolt.
4-12
EAU40493
1. Shift pedal
2. Bolt
3. Standard position
2. Move the shift pedal to the desired
position.
3. Install the bolt, and then tighten it
to the specified torque.
Tightening torque:
Shift pedal bolt:
6.5 Nm (0.7 m·kgf, 5.0 ft·lbf)
4