Rack Mounting; Installing The Server In A Rack - TYAN Tank GT20 (B5372-LC Service Manual

Bare-bones

Table of Contents

2.1

Rack Mounting

After installing the necessary components, the Tank GT20

can be mounted in a rack using the supplied rack mounting

kit.

Rack mounting kit

Sliding Rails x 2:

Sliding Brackets x 4 (Front x 2, Rear x 2)

Mounting Ears x 2

Screws Kit x 1

Mounting Brackets x 4

Follow these instructions to mount the Tank GT20 into an

industry standard 19" rack.

A) Elevated Operating Ambient - If installed in a closed or

multi-unit rack assembly, the operating ambient temperature

of the rack environment may be greater than room ambient.

Therefore, consideration should be given to installing the

equipment in an environment compatible with the maximum

ambient temperature (Tma) specified by the manufacturer.

B) Reduced Air Flow - Installation of the equipment in a rack

should be such that the amount of air flow required for safe

operation of the equipment is not compromised.

C) Mechanical Loading - Mounting of the equipment in the

rack should be such that a hazardous condition is not

achieved due to uneven mechanical loading.

D) Circuit Overloading - Consideration should be given to the

connection of the equipment to the supply circuit and the

effect that overloading of the circuits might have on overcur-

rent protection and supply wiring. Appropriate consideration

of equipment nameplate ratings should be used when

addressing this concern.

E) Reliable Earthing - Reliable earthing of rack-mounted

equipment should be maintained. Particular attention should

be given to supply connections other than direct connections

to the branch circuit (e.g. use of power strips)."

Chapter 2: Setting Up

Table of Contents