Sharp XL-DH259P Operation Manual page 15

Troubleshooting chart (continued)
USB
Symptom
Device cannot be
detected.
Playback does
not start.
Wrong time
display.
Wrong fi le name
display.
iPod and iPhone
Symptom
No sound is
produced.
No image
appears on the
TV/monitor.
iPod or iPhone
will not charge.
"This accessory is
not made to work
with iPhone" or
similar, appears
on iPhone screen.
Condensation
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation
inside the cabinet (CD pickup, etc.) or on the transmitter
on the remote control. Condensation can cause the unit
to malfunction. If this happens, leave the power on with
no disc in the unit until normal playback is possible (about
1 hour). Wipe off any condensation on the transmitter with
a soft cloth before operating the unit.
Possible cause
Is there any MP3/WMA fi le
available?
Is the device properly
connected?
Is it an MTP device?
Does the device contain AAC
fi le only?
Is it a copyright protected
WMA fi le?
Is it a false MP3 fi le?
Is Variable Bitrate fi le being
played back?
Is the File Name written
in Chinese or Japanese
characters?
Possible cause
The iPod or iPhone is not
playing.
The iPod or iPhone is not
properly connected to the
unit.
Is the AC power lead of the
unit plugged in?
The video cable is not
properly connected.
The TV/monitor's input
selection is not properly set.
The iPod TV out feature has
not been set to output video.
The iPod or iPhone is not
making full contact with the
connector.
Using iPod (3 rd generation).
The iPod or iPhone is not
supported. Refer to page 5
for compatible models.
The iPhone battery is low.
Please charge the iPhone.
iPhone is not properly
docked.
If problem occurs during operation
When this product is subject to strong outdoor interference
(mechanical shock, excessive static electricity, abnormal
supply voltage due to lightning, etc.) or if it is operated
incorrectly, it may malfunction.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power
on again.
2
If the unit is not restored in the previous operation,
unplug and plug in the unit again, and then turn the
power on.
Note:
If neither operation above restores the unit, clear all the
memory by resetting it.
Factory reset, clearing all memory
1
Press the POWER ON/STAND-BY button to enter the
power stand-by mode.
2
Whilst pressing down the OPEN/CLOSE button, press
the POWER ON/STAND-BY button until "ALL CLEAR"
appears.
Caution:
This operation will erase all data stored in memory including
clock, timer settings, tuner preset, and CD programme.
Before transporting the unit
Remove the iPod/iPhone, USB memory device and disc
from the unit. Then, set the unit to the power stand-by
mode. Carrying the unit with iPod/iPhone or USB memory
device left docked or discs left inside might damage the
unit.
Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
Keep your discs away from direct sunlight, heat, and
excessive moisture.
Always hold the CDs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre,
along the radius.
E-14