Startup Menu - Lenovo ThinkPad X230 Tablet User Manual

Table 6. Security menu items (continued)
Menu item

Startup menu

To change the computer startup settings, select Startup from the ThinkPad Setup main menu.
Attention:
• After you change your startup sequence, you must be extremely careful not to specify a wrong device
during a copy, a save, or a format operation. If you specify a wrong device, your data and programs
might be erased or overwritten.
• If you are using the BitLocker drive encryption, you should not change the startup sequence. BitLocker
drive encryption detects the change of startup sequence and locks the computer from booting.
Changing the startup sequence
To change the startup sequence, do the following:
1. Select Boot or Network, then press Enter. The default boot list is displayed, showing the order in which
devices will be started up. Even devices that are not attached to or installed on your computer are listed.
• Use the Boot submenu to specify the startup sequence that runs when you turn on the power.
• Use the Network to specify the top priority boot device that runs when Wake on LAN is enabled.
Wake on LAN is commonly used by LAN administrators in corporate networks to get remote access
to your computer.
2. Set the startup sequence by using the following keys:
• Use cursor keys to select a device.
• Use F6 or the combination of Shift and + to move the device up to a higher priority.
• Use F5 or – to move the device down to a lower priority.
• Use the combination of Shift and ! to exclude or include a device.
3. Press F10 to save the changes and restart the system.
To change the startup sequence temporarily so that the system starts up from a different drive, do the
following:
1. Turn off the computer.
120
User Guide
Submenu item
Computrace Module
Activation
Selection
• Disabled
• Enabled
• Permanently Disabled
Comments
The Intel anti-theft suspend
screen will be displayed
at next boot to enter the
suspend mode.
Enables or disables the
UEFI BIOS interface to
activate the Computrace
module. Computrace is an
optional monitoring service
from Absolute Software.
Note: If you set the
Computrace module
activation to Permanently
Disabled, you will be
unable to enable this
setting again.